This Tech News will explain how to create a report and how to backup your configuration, CNC files, and ICN files.

 

To backup your configuration, CNC files, and ICN files follow the steps below. In v6.00 Intercon was know as GGE.

 

            Insert a blank floppy disk into the control

            Press F7 – Utility

            Press F3 – Backup

            Press F1 – Config (this will backup your configuration files)

            and/or

            Press F2 – CNC (this will backup your CNC files)

            and/or

            Press F3 – ICN (this will backup your ICN files)

 

Note: For CNC and ICN files, you can select files by pressing the F1 – Toggle button or the Spacebar. If you would like to backup all files press F2 – All. If the CNC and ICN files are large, they may not fit on 1 disk and will require multiple floppy disks.

 

To create a report file follow the steps below.

 

            Insert a blank floppy disk into the control

Press F7 – Utility

            Press F7 – Report

 

To backup your CNC files and ICN files follow the steps below.

 

            Insert a blank floppy disk into the control

            Press F7 – Utility

            Press F3 – Backup

            Press F2 – CNC (this will backup your CNC files)

            and/or

            Press F3 – ICN (this will backup your ICN files)

            Press F1 – Toggle or the SPACEBAR to select individual files

            or

            Press F2 – All to select all files

            Press F10 – Accept

 

Note: If the CNC and ICN files are large, they may not fit on 1 disk and will require multiple floppy disks.

 

To create a report file follow the steps below.

 

            Insert a blank floppy disk into the control

Press F7 – Utility

            Press F7 – Report

 

To backup your CNC files and ICN files follow the steps below.

 

            Insert a blank floppy or USB device

Press F7 – Utility

            Press F3 – Backup

            Press F2 – CNC (this will backup your CNC files)

            and/or

            Press F3 – ICN (this will backup your ICN files)

            Press F1 – Toggle or the SPACEBAR to select individual files

            or

            Press F2 – All to select all files

            Press F10 – Accept

            Use the arrow key and highlight either A:Floppy or B:USB Device

            Press ENTER to activate the floppy disk or USB device

            Press ENTER again to backup the files to the floppy disk or USB device.

 

Note: If the CNC and ICN files are large, they may not fit on 1 floppy disk and will require multiple floppy disks.

 

To create a report file follow the steps below.

 

            Insert a blank floppy disk or USB device

Press F7 – Utility

            Press F7 – Report

            Use the arrow key and highlight either A:Floppy or B:USB Device

            Press ENTER to activate the floppy disk or USB device

            Press ENTER again to backup the files to the floppy disk or USB device.

 

To create a report file follow the steps below.

 

            Insert a blank floppy disk or USB device

Press F7 – Utility

            Press F7 – Report

            Use the arrow key and highlight the Destination Directory

            Press ENTER to activate the highlighted Destination Directory

            Press F10 – Accept to backup the files to that Destination Directory.